- Deep groove ball bearings
- Cylindrical roller bearings
- Aligning ball bearings
- Stainless steel bearings
- LNSERTED bearings
- Ball introduced
- Plain Bearings
- Needle Roller Bearings
- Angular contact ball bearings
- Thrust Roller Bearings
- Spherical roller bearings
- Thrust Ball Bearings
- Rolling mill bearings
- Tapered Roller Bearings
- Plastic bearings
- Linear motion bearings
| Bearing installation should pay attention to several issues | |||
| 点击数：6159 日期：2014/4/4 | |||
| A. must be good with inner and outer ring spacer thickness, spacer two Miao parallelism should not exceed 0.002mm. B. bearings must be selected. Each of the inner diameter of the bearing outer diameter difference, difference should be between 0.002 - 0.003mm, and should maintain a gap of 0.004 - 0.008mm, and the shaft neck to keep 0.0025 - 0.005mm and shell hole. In the actual installation, should with both hands thumb will fit bearing can just push the best. Roundness, shell holes at the two ends of C. bearing seat hole and the shaft neck of coaxiality, and radial shaft runout should not exceed 0.003mm. Parts in contact with the end D. bearing ring face should smear test, contact area shall not be less than 80%. E. must be directed to install. The highest point is about all the bearing inner ring radial runout at the nadir axis neck radial runout, the highest point of the outer ring of the bearing radial runout is arranged in the housing hole to form a straight line. |
|||
| On a message：China 's largest aero-engine processing base in Guizhou International Outsourcing Next information：What is the reason for the bearing locking produce ? | |||